Serenity Network Video Recorder Manuel d'utilisateur Page 120

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 160
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 119
User Manual of Network Video Recorder - User Manual
119
Chapter 9 HDD Management
9.1 Initializing HDDs
Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your NVR.
Note:
A message box pops up when the NVR starts up if there exits any uninitialized HDD.
Figure 9. 1 Message Box of Uninitialized HDD
Click Yes button to initialize it immediately or you can perform the following steps to initialize the HDD.
Steps:
1. Enter the HDD Information interface.
Menu > HDD> General
Figure 9. 2 HDD Information Interface
2. Select HDD to be initialized.
3. Click the Init button.
Figure 9. 3 Confirm Initialization
4. Select the OK button to start initialization.
5. After the HDD has been initialized, the status of the HDD will change from Uninitialized to Normal.
Note:
Initializing the HDD will erase all data on it.
Vue de la page 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 159 160

Commentaires sur ces manuels

Pas de commentaire